-1

Should I add PCB layouting and manufacturing process pictures in dissertation?

closed as off-topic by user68958, Richard Erickson, Flyto, cag51, gman May 19 at 20:18

This question appears to be off-topic. The users who voted to close gave this specific reason:

If this question can be reworded to fit the rules in the help center, please edit the question.

  • Please provide more info. What is the focus of your dissertation? What role does layouting and manufacturing play in your research? – J-Kun May 17 at 9:35
  • 1
    The results and objectives are based on the testing (not the usual hardware setup testing)carried out on the component assembly for which PCB has been designed. I have added the schematic design, but I was not sure about adding the layouting too. – Megh May 17 at 9:39
  • Does the board construction present any unusual problems to overcome for the testing to work (for example test signals having ribbon cable connectors are not even a little bit special, but flying leads for oddly-shaped components might be, especially if "poor probe connection" is a possible outcome of the testing). – Ben Voigt May 18 at 23:11
3

Unless it is the focus of the thesis ie a new process compared to previous or existing processes, then it belongs in an appendix if at all.

As the question in the body is different, then if the section / paragraph has a relevant discussion of something to do with the board, a picture might be useful.

Not the answer you're looking for? Browse other questions tagged or ask your own question.